Community post
Another lamp prototype - City
Engraving some stencil or pictures to polycarbonate is fine, but i wanted some neutral design if i can say it like that so city came to my mind. Three skyscraper like buildings in triangle with oak stand, again rgb led strip, this time with radio controler so you dont have to take care about some ir reciever. And again all design was done in Fusion 360.
Enjoy
take a look at my other projets @dantak maybe you will like them too ;)
Replies (4)
I am shitless that you did that on your own. Amazeballs! Following you know till the end of time
thx :)
Really Nice work ! I have some questions. How thick is the plexiglass? Also how do you cut and carve it ?
Hi, im not using plexiglass, its polycarbonate, its better then plexiglass, much more durable and plexi is rolled material so it have some streses inside. Its 6mm thick so all light from led strip can go inside, im cutting it on my table saw and and final cutting and carving it on open builds OX cnc( 2.5D milling machine, you buy it as kit and build it by yourself), but again, you can draw motive on polycarbonate and engrave it with tool like dremel by hand. You need to polish bottom side, thats done with sand paper to 1000 grit and then polished with torch.
hobby woodworker, lamp enthusiast, wooden rc boat model maker, wanna check my work? follow me @dantak