DIY homebrew sparge arm

Hi,

Here's the sparge arm I built for my homebrew mash tun.

I made a manifold out of copper tubes and drilles small holes. The "T" in the middle of the manifold has not been soldered on the sides. so I can move it a bit/level it.

Then, a silicone tube goes to the "T" over to feed the water from the hot liquor tank and I can set it at the height I want with the clamp.

It's not the prettiest, but it works like a charm and it's very useful!

(Make sure to use food safe soldering, no lead)